![]() ![]() Cut off excess lead wire approximately 6 to 9 in. Securely tighten the preassembled hanger ball set screw (GG).ġ3. Pull the hanger ball up tight against the hanger ball pin (HH). Insert the previously removed hanger ball pin (HH) through the two holes in the downrod (C) and align the hanger ball so the hanger ball pin (HH) is captured in the groove in the top of the downrod (C). Route the wires through the previously removed hanger ball. Route the wires through the motor coupling cover (F), canopy screw cover (E) and ceiling canopy (D).ġ2. Re-install the two downrod support set screws (EE) and tighten securely in the downrod support of the motor (A).ġ1. Secure the downrod pin (JJ) with the downrod clip (II). Align the holes in the downrod support of the motor (A) with the holes in the downrod (C) and re-install the downrod pin (JJ). Thread the downrod (C) into the downrod support of the motor (A). Route the black and white wires from the motor (A) through the downrod (C).ġ0. Remove the preassembled downrod clip (II) and downrod pin (JJ) from the bottom of the downrod (C). Retain the hanger ball pin (HH) and hanger ball for laterĨ. Remove the preassembled hanger ball pin (HH) from the downrod (C) and remove the hanger ball portion of the downrod (C). Loosen the preassembled hanger ball set screw (GG) until the hanger ball falls freely down the downrod (C). Secure the motor coupler washer (O) and upper housing cover (P) using the previously removed upper housing cover screws (FF). Re-assemble the upper housing cover (P) and motor coupler washer (O) to motor (A).Ħ. Repeat for the other blade holder arm (J).ĥ. ![]() Attach the screws (AA) to secure the blade holder arm (J) to the fl ywheel of the motor (A). ![]() Make sure the bottom edge of the blade holder arm (J) is fully seated against the fl ywheel of the motor (A). Position the blade holder arm (J) over the motor (A) with threaded posts showing. Remove the motor coupler washer (O) and upper housing cover (P) from the motor (A).Ĥ. Remove the preassembled upper housing cover screws (FF) from the top of the motor (A). Remove the two preassembled downrod support set screws (EE) on the downrod support from the motor (A). Helpful Tools (not included): AC tester light, do-it-yourself wiring handbook and wire cutters PACKAGE CONTENTSġ. fl athead screwdriver, wire strippers and step ladder Tools Required for Assembly (not included): Phillips screwdriver, 1/4 in. If any part is missing or damaged, do not attempt to assemble the product. Compare parts with package contents list and hardware contents list. Harbor Breeze LP8294LBN Platinum Santa Ana 48-in Indoor Ceiling Fan with Light Remote (2-Blade) - Use Manual - Use Guide PDF.īefore beginning assembly of product, make sure all parts are present. ![]()
0 Comments
Leave a Reply. |